Retrofit Technology
Reducing emissions from diesel engines is one of the most important air quality challenges facing the country. Even with more stringent federal heavy-duty highway and nonroad engine standards set to take effect over the next decade, millions of diesel engines already in use will continue to emit large amounts of nitrogen oxides, particulate matter and air toxics, which contribute to serious public health problems. Diesel retrofits can significantly reduce harmful air pollutants, improve the working environment of those operating diesel powered equipment, and reduce smoke and odor from diesel engines. Diesel retrofit devices usually are not original equipment, but are installed on a vehicle just prior to or after it has been serviced.
Diesel Oxidation Catalyst (DOC)
Diesel oxidation catalysts are devices that use a chemical process to breakdown pollutants in vehicle exhaust into less harmful components. More specifically, a DOC has a porous ceramic honeycomb-like structure that is coated with a material that catalyzes (causes) a chemical reaction to reduce harmful air pollutants. DOCs rarely require maintenance, come with a 100,000 to 150,000 mile warranty, can last for 7 to 15 years, and can be installed on a variety of diesel vehicles. Typically, a DOC costs between $1,000 and $1,500 and take about 1 to 2 hours to install.
The State of Indiana has negotiated a more competitive price for this equipment. For more information regarding the Quantity Purchase Agreement for Diesel Oxidation Catalysts please contact the Air Senior Environmental Manager at (317) 233-0425 or info at idem.IN.gov.
Diesel Particulate Filter (DPF)
Diesel particulate filters are ceramic devices that collect particulate matter in the vehicle exhaust stream. The heat produced by the vehicle exhaust heats the ceramic filter and allows the particles to break down (or oxidize) into less harmful components. Unlike diesel oxidation catalysts (DOC), DPFs must be used in conjunction with ultra low sulfur diesel (ULSD) fuel and work best on diesel engines built after 1995. Therefore, knowing the age and type of each engine in the fleet as well as the exhaust temperature is an important part of the retrofit project. Manufacturers recommend that DPFs be cleaned about every 100,000 miles. Most DPFs come with a 100,000 to 150,000 mile warranty. Typically a DPF cost between $5,000 and $7,000 and take about 6-8 hours to install.
| Technology | CO | HC | PM | Per Unit Cost |
|---|---|---|---|---|
| Diesel Oxidation Catalyst (DOC) | 40% | 70% | 40% | $1,000 - $1,500 |
| Diesel Particulate Filter (DPF) 1,2 | 75% | 85% | 90% | $5,000 - $7,000 |
1) Reductions are calculated based on the use of ULSD
2) Actual emission values vary with engine design
Aftermarket Auxiliary Heaters
Aftermarket auxiliary heaters can be used to warm up engines and passenger compartments in colder climates. This equipment runs off the diesel fuel tank or the vehicle's electrical outlets and includes a timer that can be programmed to automatically start the heating function. There are three types of heaters:
- Engine Block Pre-Heaters are used to heat the engine block for a warm start. Block engine pre-heaters cost approximately $1200 - $1500, installed. Some of the reported benefits of these heaters are lower emissions and fuel savings, longer engine oil life, less wear-and-tear on the engine, and relatively easy installation and maintenance.
- Compartment/Engine Block Heaters warm up the engine block and passenger compartments simultaneously while using an auxiliary heater. These heaters cost approximately $2300 - $2500 installed. These heaters are especially useful for nighttime-activity buses and buses that transport very young and/or special-needs children. In addition, the radiant heat keeps the windows from frosting or fogging - a safety concern.
- Electric Plug-in Block Heaters warm up the engine block by heating the engine coolant or oil. They are powered by electricity and are available in a range of voltages and watts, drawing between 1000 - 1500 watts per bus per hour. They include a timer that can automatically start or turn off the heater. A heater is mounted on the engine block of each bus and is plugged in when the bus is parked at the depot. Even in the coldest climates, engines will have a "warm start." Such heaters usually cost less than $100.
U.S. EPA-Verified Technology
The U.S. Environmental Protection Agency (U.S. EPA) evaluates the emission reduction performance of retrofit technologies such as DOCs and DPFs, including their durability, and identifies engine operating criteria and conditions that must exist for these technologies to achieve those reductions. Since the U.S. EPA generally receives such results of testing conducted on a limited number of diesel engine models, a conservative approach is taken to establish the verified levels of reduction. In most cases the actual reductions are higher than verified values.
- Retrofit technologies that the U.S. EPA has verified
- Information about the U.S. EPA's verification process
- What should I do with my old computers and electronics?
- Where can I recycle?
- What are “Pay-as-You-Throw” programs?
- How can I get funding for recycling programs?
- What is “household hazardous waste”?
- Why is mercury dangerous?
- What is composting and how do I do it?
- What are the benefits of recycling?
- Where can I find information about available IDEM grants, loans, or funds?
- Where can I find information about flooding?
